ADSS/OPGW Hardware

To order the following components please have specific information regarding Application, Cable Construction/Part Number and Span/ Loading details. Without this specific information FIS is not able to accurately quote any ADSS products. Please call for pricing.

FIBERLIGN LITE TENSION DEAD-ENDS

The FIBERLIGN Lite Tension Dead-end is a dielectric dead-end designed to terminate short-span, low-tension ADSS fiber optic cables in low-voltage environments. The product effectively transfers the low axial load on the cable at the end of the dead-end legs to allow uniform radial compression near the dead-end loop. 

This component must be ordered specifically based on cable Outside Diameter and span length. Part number will vary depending on cable O.D.

FIBERLIGN LITE SUPPORT (FLS)

The FIBERLIGN Lite Support (FLS) system is designed to gently, but firmly, support All-Dielectric Self- Supporting (ADSS) cable. It is intended for tangent support installations on lines that feature relatively low voltages, very short spans and low mechanical loads. For most applications, the maximum line angle recommended is 20 degrees.

This component must be ordered specifically based on cable Outside Diameter and span length. Part number will vary depending on cable O.D.

FIBERLIGN DIELECTRIC SUPPORT (FDS)

The FIBERLIGN Lite Support (FLS) system is designed to gently, but firmly, support All-Dielectric Self- Supporting (ADSS) cable. It is intended for tangent support installations on lines that feature relatively low voltages, very short spans and low mechanical loads. For most applications, the maximum line angle recommended is 20 degrees.

This component must be ordered specifically based on cable Outside Diameter and span length. Part number will vary depending on cable O.D.

FIBERLIGN ALUMINUM SUPPORT (FAS)

The FIBERLIGN Aluminum Support (FAS) is designed to gently, but firmly support All-Dielectric Self-Supporting (ADSS) cable. The FAS features the following: integrated bolt or band mount design, hinged keeper and base, single- bolt clamping, and stackability for multi-cable installations. For higher voltages (where track-resistant ADSS cables are required), longer spans and/or higher loads, use either the FIBERLIGN Aluminum Suspension with rods or the FIBERLIGN Dielectric Suspension. Maximum line angle typical is 20 degrees or less.

This component must be ordered specifically based on cable Outside Diameter and span length. Part number will vary depending on cable O.D.

FIBERLIGN ALUMINUM SUSPENSION (FASN)

The FIBERLIGN Aluminum Suspension (FASN) is designed to gently, but firmly support All-Dielectric Self- Supporting (ADSS) cable. The FASN features the following: Short-to-Medium Span Option, Low-to-High Voltage Environment acceptance.

This component must be ordered specifically based on cable Outside Diameter and span length. Part number will vary depending on cable O.D.