-
Anritsu Wheeled Hard-Side Protective Case for Anritsu PIM Master SKU: 760259R Unit of Measurement : EA$1,175.00 -
-
Divot Index Matching Gel Replacement Cartridges Bare Fiber Testing Device 3 Pack SKU: DVTRC3 Unit of Measurement : Pkg$70.00 -
FIS Utility/Splice-On Connector Oven Shelf for Lightera Splicers SKU: F1FTLSHELF Unit of Measurement : EA$49.95 -
![FIS Mechanical Splice Kit]()
-
![FIS Fusion Splice Protection Sleeve Standard 40mm 3mm After Shrink Clear 50 Pack]()
FIS Fusion Splice Protection Sleeve Standard 40mm 3mm After Shrink Clear 50 Pack SKU: F1100240C-50 Unit of Measurement : 50PK$10.50 Qty Buy as low as $9.45 -
![Corning® ClearCurve® OM4 Multimode Fiber]()
Corning® ClearCurve® OM4 Multimode Fiber, Bare Fiber, 50/125um G.651.1 Compliant SKU: CLEARCURVEOM4 Unit of Measurement : Mtr$0.30 -
![TLC Ribbon Cable 12 Fiber Multimode 50/125um (OM3) ClearCurve Plenum Aqua]()
TLC Ribbon Cable 12 Fiber Multimode 50/125um (OM3) ClearCurve Plenum Aqua SKU: M50RB12CGNPA Unit of Measurement : Mtr$4.25 -
![TLC Tight Buffer Cable 900um Multimode 50/125um OM3 Aqua]()
TLC Tight Buffer Cable 900um Multimode 50/125um OM3 Aqua SKU: M50TB01CGNPA Unit of Measurement : Mtr$0.35 -
![AFL Telecom ADSS 24 Fiber MM 62.5um Mini Span 424]()
AFL Telecom ADSS 24 Fiber MM 62.5um Mini Span 424 SKU: AE0246C520AA4 Unit of Measurement : Mtr$6.65 -
![FIS Ribbon/Buffer Tube Fan-Out Kit 12 Fiber Color Coded 36" Tubing Length Accepts 250um]()
FIS Ribbon/Buffer Tube Fan-Out Kit 12 Fiber Color Coded 36" Tubing Length Accepts 250um SKU: F1BF1236M Unit of Measurement : EA$15.95 Qty Buy as low as $14.36 -
![FIS Corrugated Innerduct HDPE Single Wall Orange 250ft Coil]()
FIS Corrugated Innerduct HDPE Single Wall Orange 250ft Coil SKU: F114363P250 Unit of Measurement : Roll$235.75
Splicing
Fusion Splicing is a preferred way to join two fibers together by using heat. Whether the fiber was broken or not long enough, a fusion splicer will make your job easier. Splicing fiber optic cable is fairly simple procedure. Prepared fiber ends are placed in the splicer and automatically aligned and then fused together. This method ensures greater reliability with less light being scattered or reflected back by the splice. The splice itself if done correctly should be as strong as the original optical fiber.
